Design and Modeling of E-Bike

Authors

  • Mahesh Palavalasa Assistant Professor, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • R. S. R. Krishnam Naidu Associate Professor, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • Gayathri Garrepalli Student, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • Annapoorna Pinninti Student, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • Sai Ganesh Appalabathula Student, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • Sudheer Kumar Kalyana Student, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • Srinivas Molli Student, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India
  • Uma Shankar Narem Student, Department of Electrical and Electronics Engineering, Nadimpalli Satyanarayana Raju Institute of Technology, Visakhapatnam, India

Keywords:

Electric bike, Power, Economical, Hub motor, Battery, Analysis, Chassis

Abstract

This project details about the Electric Bike which runs on the battery thereby providing voltage to the motor. This project compromises with design and fabrication of Electric Bike which makes use of Electric energy as the primary source and solar energy, if possible, by attaching solar panels. It also highlights on the design aspects of the bike. There is a provision for a charging the battery by ejecting it from the main system. The electrical power generated which is used to run the bike can give better fuel economy compared to conventional vehicle, better performance and also causes less pollution. The project is to design a feasible yet highly adaptable E-bike. As the number of motor vehicles on the roads throughout the world increases at staggering rate each year, the dependence on oil-based fuel grows almost unchecked. The increased use of non-renewable fossil fuels brings with it environmental problems such as: the “greenhouse effect”, health problems for city delivers and concern over the stability of fuel supply. To move away from this dependence on oil, a vast amount of money is being spent on the development of electrical vehicles (EVs) that may be produced. This project presents a study of electrical motorcycle design. The aim of this study is to investigate how to design a simple, cost-effective model of electrical motorcycle with intelligent control system. This can be implemented by removing the internal combustion engine, the exhaust system and other unnecessary components from the motorcycle and replaced by an electrical motor, an intelligent controller.

Downloads

Download data is not yet available.

Downloads

Published

12-06-2022

How to Cite

[1]
M. Palavalasa, “Design and Modeling of E-Bike”, IJRAMT, vol. 3, no. 6, pp. 38–42, Jun. 2022.

Issue

Section

Articles